Installing A Tape Drive - Nortel CallPilot User Manual

108 Chapter 9 Replacing media drives
3
4
5
6
7
8
9
10

Installing a tape drive

This procedure provides instructions for installing a tape drive on a server
that currently does not have a tape drive.
Copyright © 2007, Nortel Networks
.
If you are installing a tape drive, configure it as described in
configure the tape drive" (page
Slide the new drive into the media drive carrier, and secure it with
the screws that were previously removed.
Reattach any media drives that you removed to access a specific
media drive slot.
Position the media drive carrier in the media drive bay, leaving
enough room to reach behind the carrier, and attach the connectors.
Carefully connect the existing signal and power cables as shown in
"Cabling example" (page
Note: If your tape drive is a narrow device, you require a
wide-to-narrow adapter to connect to the wide SCSI cable.
Slide the carrier into the media drive bay.
Note: Ensure that the cables are free and undamaged.
Secure the media drive carrier to the chassis with four Phillips-head
screws.
Replace and lock the front bezel.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
109).
109).
—End—
"To
Nortel Networks Confidential