Replacing The Alarm Board - Nortel CallPilot User Manual

Replacing the alarm board

The 1002rp server alarm board and status panel are used to monitor and
indicate the server status. The basic hardware check on page
hardware check" (page 17)
these units are damaged, replace them immediately.
Requirements
Before replacing the alarm board or panel display, gather the following tools:
•
•
•
To replace the alarm board
Step
1
2
Copyright © 2007, Nortel Networks
.
CAUTION
Risk of equipment damage
Take precautions to protect computer boards. ESD can damage
boards and make them unusable. Wear an ESD wrist strap.
a Phillips screwdriver
an antistatic wrist strap
the replacement components
Action
Power off the server.
Loosen the two thumbscrews securing the faceplate to the left of
the 1002rp server power supply modules (see A in
carrier" (page 94)).
If needed, use a flat-blade screwdriver. The thumbscrew must rotate
freely and not contact the chassis threads.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
Replacing the alarm board 93
fails if the board is defective or damaged. When
"Basic
"Alarm board
Nortel Networks Confidential