Nortel CallPilot User Manual page 92

92 Chapter 8 Replacing basic chassis components
5
6
7
8
9
10
11
12
If the fuse blows after replacement, swap one power supply module with the other.
If this does not work, call your Nortel customer support representative.
Copyright © 2007, Nortel Networks
.
Fuse receptacle
Slide the fuse receptacle out of the fuse chamber.
Note: Observe how the blown fuse is positioned in the
receptacle.
Remove the blown fuse from the fuse receptacle.
Install the approved replacement fuse. Use a flat-blade screwdriver
to screw in the fuse receptacle with a push and 1/4 clockwise turn.
Slide the fuse receptacle back into its chamber.
Fasten the fuse receptacle with a flat-blade screwdriver.
Plug the power cable back into the power input socket on the server.
Plug the power cable into the wall outlet.
Power on the server.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
—End—
ATTENTION
Nortel Networks Confidential