Nortel CallPilot User Manual page 146

146 Chapter 14 Maintaining the Pentium III SBC card
5
6
7
8
9
10
11
12
To configure the Pentium III SBC
Copyright © 2007, Nortel Networks
.
Result: The server boots from the CD-ROM and displays the
installation menu.
Press 2 to select Utilities (BIOS, Firmware, etc...),
and then press Enter.
Press 1 to select Update 1002rp BIOS to version
NNCXUA07 and then press Enter.
Result: The system prompts you to confirm that the single board
computer (SBC) is a SLE model.
Choose yes (Y) to confirm.
Result: The system prompts you to save the existing BIOS.
Type n and then press Enter.
Result: The system prompts you to enter the file name.
Type nncxau07.rom and then press Enter.
Result: The system prompts you to program the boot block.
Type y and then press Enter.
Result: The system updates the BIOS and then prompts you to
reboot the server.
Press Ctrl+Alt+Delete to reboot the CallPilot server.
Result: The CallPilot server reboots.
During the reboot sequence, check the version of the BIOS on the
top of the first screen. The BIOS version must be NNCXUA07.
Tip: If the BIOS version is not NNCXUA07, then check if the J10 and
J11 jumpers are both in the top position. Power down the server,
remove the single board computer (SBC) board and set the jumpers
to the correct position. Follow the electrostatic discharge (ESD) rules
to prevent static electricity from damaging the SBC board.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
—End—
Nortel Networks Confidential