Nortel CallPilot User Manual page 145

When to upgrade the BIOS
Do not upgrade the BIOS unless specifically instructed to do so by your
Nortel representative. The CallPilot server is shipped to the customer with
the required minimum BIOS vintage, so an upgrade is only necessary if
Nortel deems this necessary to solve a system problem. The minimum
release BIOS for CallPilot 4.0 is NNCXUA07 or later.
When to configure the BIOS
BIOS configuration is performed at the factory before the CallPilot server is
shipped to the customer. It may be necessary to reconfigure the BIOS at a
customer site after a BIOS or CMOS failure and recovery.
Requirements for upgrading or reconfiguring the BIOS
CallPilot Image CD (1and 2)
To upgrade the BIOS
You must perform both of the following procedures to upgrade the BIOS:
Step
1
2
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
Action
Upgrade the BIOS ("To upgrade the BIOS" (page
Configure the SBC ("To configure the Pentium III SBC" (page
Action
CAUTION
Risk of data loss
Perform this procedure only if specifically instructed to do so by
your Nortel representative.
Disconnect the cable that connects the CallPilot server to the Nortel
server subnet.
Power on the CallPilot server.
Insert the CallPilot Image CD 1 of 2 for the platform into the CD-ROM
drive.
Set the CallPilot server BIOS to boot from the CD-ROM.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
Configuring the 1002rp Pentium III BIOS 145
—End—
145)).
146)).
Nortel Networks Confidential