Nortel CallPilot User Manual page 79

Step
1
2
To remove the server cover
Step
1
2
3
4
5
To replace the front bezel after maintenance is complete
When the CallPilot server maintenance is complete, replace the front bezel.
Copyright © 2007, Nortel Networks
.
Action
Unlock and open the double doors of the front bezel. See A in
bezel removed" (page
Firmly grasp the front bezel by the hand-holds on either side of the
chassis, and pull the front bezel from the chassis. See B in
bezel removed" (page
Action
DANGER
Risk of electric shock
High current inside the chassis can cause severe injury.
CAUTION
Risk of equipment damage
Take precautions to protect internal components. Electrostatic
discharge (ESD) can damage boards and make them unusable.
Wear an ESD wrist strap.
Remove the front bezel.
Power down the server and disconnect all power cords.
Loosen the three thumbscrews at the rear of the top cover.
Remove the server cover by pulling the cover toward the rear of the
chassis, and then lifting it up and off.
Clip the lead from your ESD wrist strap to an unpainted metal section
of the chassis.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
Removing the front bezel and server cover 79
78).
78).
—End—
—End—
"Front
"Front
Nortel Networks Confidential