Nortel CallPilot User Manual page 30

30 Chapter 4 Using Windows online diagnostic tools
Tracert syntax
The tracert command uses the following syntax:
tracert [-d] [-h maximum_hops] [-j host_list]
[-w timeout] [target_name]
Tracert parameters
the following table shows the tracert parameters.
Tracert parameters
Parameter
-d
-h maximum_hops
-j host-list
-w timeout
target_name
To run the tracert command from Windows
Step
1
2
3
4
The arp command
The arp command displays and modifies the IP-to-physical address
translation tables used by Address Resolution Protocol (ARP).
Copyright © 2007, Nortel Networks
.
Description
Specifies not to resolve addresses to hostnames.
Specifies the maximum number of hops to search for
the target.
Specifies a loose source route along the host list.
Waits the number of milliseconds specified by the
timeout for each reply.
Specifies the name of the target host.
Action
Click Start → Programs → Accessories → Command Prompt.
Result: The Command Prompt window appears.
At the Command prompt, type the following command:
tracert [-d] [-h maximum_hops] [-j host_list] [-w
timeout] [target_name]
Example: tracert 200.286.0.32
Press Enter.
Result: The system runs the tracert utility.
Type Exit to exit the Command Prompt window and return to
Windows.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
—End—
Nortel Networks Confidential