Nortel CallPilot User Manual page 110

110 Chapter 9 Replacing media drives
5
To install a new tape drive (no tape drive previously installed)
Step
1
2
3
4
5
6
7
8
9
10
Copyright © 2007, Nortel Networks
.
Leave the remaining settings at the default values.
Action
CAUTION
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
Courtesy down CallPilot, and then power down the server.
Ensure that the tape drive settings are as described in
the tape drive" (page
Remove the chassis cover.
Remove the media drive carrier (see
carrier from the chassis" (page
Slide the new tape drive into the media drive carrier, and secure it
with four undercut Phillips-head screws.
Note: You may need to first remove other media drives from the
carrier to access the tape drive slot.
Reattach any media drives that you removed to access the tape
drive slot.
Position the media drive carrier in the media drive bay, leaving
enough room to reach behind the carrier, and attach the connectors.
Carefully connect the existing signal and power cables as shown in
"Cabling example" (page
Slide the carrier into the media drive bay.
Note: Ensure that the cables are free and undamaged.
Secure the media drive carrier to the chassis with four Phillips-head
screws.
Result:The tape drive is installed.
Nortel CallPilot
1002rp Server Maintenance and Diagnostics
NN44200-701 01.02 Standard
5.0 4 April 2007
—End—
109)".
"Removing the media drive
103)).
109).
""To configure
Nortel Networks Confidential