Setting The Tape Drive Scsi Id - Nortel CallPilot 201i Hardware Installation

94 Chapter 7 Preparing peripheral devices
DIP switch
4
5
What is next?
If you are also installing a tape drive, set the tape drive SCSI ID (see
"Setting the tape drive SCSI ID" (page
drive device termination (see

Setting the tape drive SCSI ID

Introduction
This section describes how to set the tape drive SCSI ID.
You must power down the tape drive before changing the SCSI ID.
To set the tape drive SCSI ID
The SCSI ID setting is located on the back of the tape drive. See the
following diagram.
To change the SCSI ID, use the blade of a screwdriver to press either the
plus (+) or minus (-) button on the SCSI ID switch. Set the SCSI ID to 5.
Copyright © 2007, Nortel Networks
.
Description
Block
Eject
Note: The tape drive discussed in this section is the Tandberg SLR5
tape drive (NTRH9038). This is currently the only supported tape drive.
Note: The appearance and size of the tape drive cabinet is subject to
change. The diagram is an example of the key components.
Nortel CallPilot
201i Server Hardware Installation
NN44200-301 01.01 Standard
5.0 15 February 2007
Setting
OFF
OFF
Note: If this switch is set to ON, the
eject button on the CD-ROM drive is
disabled. To eject the CD-ROM from
the drive, a software eject command
must be sent over the SCSI bus.
94)); otherwise, set the CD-ROM
"Setting SCSI device termination" (page
ATTENTION
95)).
Nortel Networks Confidential