Using Model 5380 Ethernet and Model 5580 Token Ring Routers
5.
6.
Installing the Router
To install and secure the router module in the chassis, follow these steps:
1.
Figure 2-10.
2.
2-12
Press straight down on the net module at the ends of the connector to seat
it on the baseboard.
When you push the net module into the baseboard connector, it should attach
easily. If there is any resistance, STOP and recheck the pins before forcing the
connector down.
Insert and tighten the two mounting screws on the front panel.
Use the screws you removed from the filler panel.
Remove the filler panel from the chassis slot where you intend
to install the module (see Figure 2-10).
Removing a Filler Panel
Verify that the memory card is installed.
Refer to "Installing the Memory Card" earlier in this chapter.
50 00
M od el
3444.3
112768 Rev. B