Figure 3-10. Connection Table Changes - Bay Networks 5380 User Manual

2.
3.
--------
Changing backplane attachments...
Enter cluster number (0 if done, 1 to 4):
Figure 3-10.
4.
112768 Rev. B
Enter the cluster port number for the attachment (backplane segment)
you want to set: interface 1, 2, 3, or 4.
For the results shown in Figure 3-10, 1 is entered at the prompt.
The following prompt is displayed:
Enter new backplane attachment (13 = disconnect, 1 to 12):
Enter the slot number of the attachment (backplane segment) you want
to change.
For the results shown in Figure 3-10, 8 is entered at the prompt.
The connection table is displayed to show the change.
If you want to disconnect (segment) an interface from the backplane, enter 13.
Cluster
Port Status
--------
1 Connected
2 Segmented
3 Segmented
4 Segmented
Connection Table Changes
Repeat steps 2 and 3 for each interface you want to attach to the
backplane.
Initializing and Setting Up the Routers
Backplane
Attachments MAC Address
------------- -----------------
8 00-00-00-00-00-00
None 00-00-00-00-00-00
None 00-00-00-00-00-00
None 00-00-00-00-00-00
3-17