Configuring An Interface For Network Management - Bay Networks 5380 User Manual

Using Model 5380 Ethernet and Model 5580 Token Ring Routers
Configuring an Interface for Network Management
After booting the router with the ti_5000.cfg file and establishing a new
Technician Interface session, you are ready to run the installation script
(install.bat) to configure the initial IP interface.
The installation script prompts you to enter the network information that
dynamically configures the initial IP interface. You configure subsequent
interfaces with Site Manager, or other router management software.
To run the script, you need to connect the router module to the appropriate Model
5000 chassis slot as described in"Connecting a Router Module" earlier in this
chapter.
Note: Use install.bat once to configure the initial interface. To configure other
interfaces, use Site Manager or other router management software to create
new configurations.
To run the script:
1.
Table 3-2. Technician Interface Commands for the Installation Script
To Do the Following
Accept a default value
Repeat a step
(for example, if you make a
mistake)
Quit out of the installation
script
2.
3-10
Review Table 3-2 for the commands you use to run the script.
Action
Press Return
Press Control-c
Press Control-c
Start the script by entering the following command:
run install
Result
Your terminal displays the default values in brackets; for
example, [E21].
When prompted by Terminate script y/n?, type n.
The Technician Interface returns to the beginning of the
step so that you can reenter the information.
When prompted by Terminate script y/n?, type y.
The installation script terminates and returns to the
Technician Interface prompt. Reboot the router using the
ti_5000.cfg file before rerunning the installation script.
112768 Rev. B