Booting With The Ti_5000.Cfg File - Bay Networks 5380 User Manual

Using Model 5380 Ethernet and Model 5580 Token Ring Routers
3.
Table 3-1.
File name*
ti_5000.cfg
config
debug.al
install.bat
s5000.exe
s5000diag.exe
s5000boot.exe
*. Other files may be in the directory.
4.
If your installation files or software image is not available, contact the Bay
Networks Technical Response Center.

Booting with the ti_5000.cfg File

You initialize the router with the ti_5000.cfg file. This file is a special file that
boots the router without configuration. You then run the installation script to
create an initial configuration. Never change the ti_5000.cfg file or overwrite it
with another configuration file.
Booting a new router uses the config file by default. When the router boots
through the boot command or is powered up, it uses the configuration file named
config and the image file named s5000.exe. When the router is shipped, the config
and ti_5000.cfg files contain the same information.
3-8
Verify that the directory lists the installation files shown in Table 3-1, or
their equivalents.
Installation File Names
Verify that the directory contains the correct software image (s5000.exe).
File Type
Initial configuration file
Configuration file
Alias file
Installation script file
Router software image
Router diagnostic PROM image
Boot PROM image
112768 Rev. B