Verifying The Installation; Figure 2-13. Led Displays On The Router Modules - Bay Networks 5380 User Manual

Verifying the Installation

Immediately after you have installed the router module, observe that all LEDs (see
Figure 2-13) light amber, then green, then off. If the board is installed and
functioning properly, you will see the following LEDs light during the diagnostic
and boot sequence:
•
•
After the diagnostics have successfully completed:
•
•
•
When the router module has finished booting and is operational, the annunciator,
Run, and BP LEDs light green; the Net 1, Net 2, and PPX LEDs light green if
these options are installed.
Refer to Appendix B, "LEDs," for all the LED definitions. Refer to Chapter 3,
"Initializing and Setting Up the Routers," to complete the installation.
5380
Ethernet Router
Segment Connection
S1 S2 S3 S4
S5 S6 S7 S8
S9 S10 S11 S12
Module Status
Run Boot Diag
Net1 Net2 BP PPX
PPX Transmit
A B C D
PPX Arbiter
A B C D
Figure 2-13. LED Displays on the Router Modules
112768 Rev. B
The annunciator lights amber.
The Run LED blinks green to indicate the diagnostics are running.
The Boot LED is green to indicate the boot process. The Boot LED turns off
when the process is complete.
The Run LED is off while the router module is booting.
The Diag LED remains off to indicate that the tests have run successfully.
Annunciator
Segment-level LEDs
Module Status LEDs
PPX-level LEDs
6561
5580
Annunciator
Token Ring Router
Ring Connect
R5
Ring-level LEDs
R1 R2 R3 R4
R6 R7 R8 R9
Module Status
Run Boot Diag
Module Status LEDs
Net1 Net2 BP PPX
PPX Transmit
A B C D
PPX-level LEDs
PPX Arbiter
A B C D
Installing the Routers
6562
2-15