Commissioning; Checking Spa Communication - ABB SPA-ZC 400 Installation And Commissioning Manual

1MRS755347
7.
7.1.
Ethernet Adapter
SPA to IEC 61850 Gateway
Installation and Commissioning Manual

Commissioning

The downloaded CID file is taken into use when SPA-ZC 400 is restarted
automatically .
Normally, the device is reset automatically after the configuration is
downloaded with Communication Engineering Tool (CET) for SPA-ZC 40x.
After downloading the configuration you can check the basic TCP/IP
functionality with the ping command in command prompt:
c:\>ping x.x.x.x.
The IEC 61850 communication is checked from the IEC 61850 client either
by using the exported CID or ICD file or by browsing the SPA-ZC 400
IEC 61850 namespace.
You can see how the configuration process is progressing from the diagnostic
LEDs. When the SPA-ZC 400 configuration is completed, the green LED is
on.
If SPA-ZC 400 is online with the IEC 61850 client, you can check the general
configuration status of SPA-ZC 400 from the data model LD0.LLN0.Health.
stVal:
1. OK - configuration is completed successfully.
2. Warning - no clock synchronization.
3. Alarm - during the configuration appeared errors.
If the configuration fails, check the error log files from the SPA-ZC 400 file
system. The status and error logs are located in the /log directory. For more
information about maintenance, refer to Chapter 9. Maintenance and service.

Checking SPA communication

If the configuration is completed successfully, you can check the resettable
diagnostic counters through the IEC 61850 data model or SPA-ZC 400 file
system.
SPA-ZC 400 Diagnostic counters are part of the LD0.LLN0.COmDiag
attributes. The data object type is ABB-specific extension in IEC 61850 data
model and contains the counters as data attributes. It is possible to reset the
counters by writing 1 into ctlVal. It is not recommended to put the counters
into the data set because the counter values are updated only during a read
operation.
SPA-ZC 400
61