Enabling Connectivity Packages - ABB SPA-ZC 400 Installation And Commissioning Manual

SPA-ZC 400
5.3.1.
26
Ethernet Adapter
SPA to IEC 61850 Gateway
Installation and Commissioning Manual
4. The Connectivity Package Installation program starts. In this dialog, click
Next.
With the Back button return to the previous dialog, and with the
*
Cancel button, exit the installation wizard. This applies to all the
dialogs in the installation wizard.
5. Read the License Agreement, select the option I accept the license
agreement and click Next to continue the installation.
If the option I do not accept the license agreement is selected, the
*
Next button is not available and you cannot continue the installation.
6. Select the folder in which the application is to be installed.
To select the default folder shown at the bottom of the dialog, click
*
Next.
To select another folder, click Browse, choose the folder you want and
*
click Next.
7. Click Next to begin the installation.
8. Follow the progress of the installation in a dialog, which also shows the
directory path where the files are copied to. At this point, you can still
cancel the installation by clicking Cancel.
9. A dialog opens to show that the Connectivity Package has been
successfully installed. Close the dialog and finish the installation by
clicking Finish.
After installing a new CET for SPA-ZC 40x version or new
Connectivity Packages, always activate the correct Connectivity
Package version again by using the Connectivity Package
Manager.

Enabling Connectivity Packages

Use Connectivity Package Manager to enable the Connectivity Packages for
SPA-ZC 400.
Only one version of each Connectivity Package can be enabled
at a time.
1. Double-click the icon on the computer's desktop to start the
Connectivity Package Manager.
2. Select the corresponding Connectivity Package to enable it for
SPA-ZC 400.
3. Click OK to apply the selection, see Fig. 5.3.1.-1.
1MRS755347