Install The Access Point Under-Seat - Extreme Networks AP5050U Installation Manual

Install the Access Point
Table 8: AP5050U Mounting Bracket Usage (continued)
Mounting bracket and Wall install
part number
MBO-ART02 Yes
30520 No
(WS-MBO-POLE01
bracket)
Warning
When installing the access point on a wall or to a pole, the cable glands must face down.
Note
When using the MBO-ART02 articulating mounting bracket with the access point, set the
bracket downward tilt to less than 20 degrees to prevent water ingress.
Related Topics
Installation Do's and Don'ts
AP5050U Purchase Order Information

Install the Access Point Under-Seat

The AP5050U is used with the EIO-04 mounting kit for under-seat installation.
The EIO-04 under-seat mounting kit can be installed on a:
•
Slope
•
Flat horizontal surface such as stadium floor
Pole install Under-seat install
Yes No
Yes (must be used No
with the MBO-
ART02 bracket)
on page 18
on page 13
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
Install the Access Point Under-Seat
Notes
The articulating mounting
bracket is paired with the
POLE01 bracket for pole
installations.
For wall installations, the wall
must be strong enough to
support the access point during
inclement weather.
If the pole diameter is <= 1.0
in. (25.4 mm), use small cable
clamp. If the pole diameter is
between 5.0 in. - 7.0 in. (178.0
mm), use large cable clamp. For
any other pole diameter, provide
your own stainless steel cable
clamp. The band must be 0.5 in.
(12.7 mm) wide.
The POLE01 bracket can be used
only when paired with the MBO-
ART02 bracket.
21