Connect The Eth1 Or Eth0 Cable Through The Metal Sloping Bracket - Extreme Networks AP5050U Installation Manual

Connect the ETH1 or ETH0 Cable through the
Metal Sloping Bracket
Learn how to connect the ETH1 or ETH0 cable through the large conduit hole on the metal sloping
bracket.
About This Task
The following hardware is required to attach the ETH1 or ETH0 cable through the large conduit hole on
the metal sloping bracket:
•
ETH1 or ETH0 cable
•
Two blank conduit covers to cover the front and the rear holes on the side of the service panel base
•
One metal sloping bracket
Note
The conduit cover used on the metal sloping bracket can extend above the concrete floor but,
cannot extend above the slope.
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point 51