Secure The Access Point After Installation - Extreme Networks AP5050U Installation Manual

Secure the Access Point after Installation

3. Place the service panel top over the service panel base and lock it into place using the captive screw.
Figure 17: Plastic service panel top captive screw
Callout
1
4. Tighten the captive screw to 4.5 in-lbs by hand.
Secure the Access Point after Installation
Details about installing a security cable on the access point after installation.
Before You Begin
The following hardware must be supplied by the user for safety cable installation:
•
A 3 mm diameter security cable
•
Lock to secure the ends of the security cable
About This Task
You can secure the access point to the mounting environment using a 3 mm diameter safety cable. The
safety cable is used to enhance the physical security of the access point after installation.
Procedure
1. Insert the safety cable through the security cable hole on the metal base of the access point.
Figure 18: Security cable hole on the access point
2. Push the cable through the security hole until you see it come out on the other side of the metal
base.
3. Insert a lock through the looped ends of the cable and lock it in place.
44 ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
Description
Plastic service panel top captive screw
Install the Access Point