Installation Do's - Extreme Networks AP5050U Installation Manual

Install the Access Point
Figure 3: AP5050U Gland Body
Table 7: Gland Body Features
Callout
1
2
3
4

Installation Do's:

Orientation:
•
The access point can be mounted in almost any orientation.
•
The side with the glands can be horizontal, facing down (ideal position), or anything in-between.
User I/O:
•
Only the gland caps must be removed to install the ETH0 or ETH1 LAN RJ45 cable. Torque the gland
caps between 8 in-lbs. to 10 in-lbs.
•
The LAN cables must have a minimum radius of 1 in. and a 3 in. minimum drip loop. The loop allows
gravity to carry moisture away from the glands.
•
The console cap must be removed to install the console LAN RJ45 cable. Torque the console cap to
12 in-lbs. to 15 in-lbs.
•
If used, torque the ground screw to a minimum of 12 in-lbs.
Description
Vent - do not loosen the vent. Do NOT remove the vent or it's protective cap.
Gland cap hex - remove only as needed to attach a LAN cable
Gland body hex
Note: Do not loosen or unscrew the gland body hex.
Console cap hex - retighten to 15 in-lbs.
Note
The only mounting orientation restriction is with the access point glands. The best practice
is to have the glands on the downward side to maximize water draining away from the
glands.
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
Installation Do's:
19