Access Point Bracket Usage And Mounting Options - Extreme Networks AP5050U Installation Manual

Access Point Bracket Usage and Mounting Options

Power or Pressure Washers:
•
The best practice is to keep a minimum distance of 24 inches between the pressure washer nozzle
and the access point.
•
Ensure that the maximum water pressure does not exceed 4000 psi.
•
Fifteen degres (15 degrees) is the narrowest nozzle that should be used for pressure washing.
Under bench and stadium riser installations only:
•
If the AP5050U is mounted with a portion above the stadium riser, ensure there is a solid backing
plate covering the entire access point and the service panel (EIO-03-SP) bottoms.
•
When mounted on the riser, there must be a minimum of 1 in. of clear space below the mounted
access point surface that is closest to the floor.
•
In areas where the temperature gets to freezing or below, apply anti-seize material to the threads of
the M6 screws (that holds the access point to a bracket) and M4 screws (that holds the service panel
to the access point) prior to inserting the screw. Tighten the M6 screws to around 30 in-lbs. and the
M4 screws to about 10 in-lbs.
Under seat installation only:
•
Tighten the EIO-04 M6 screws to around 30 in-lbs. and the EIO-03-SP (service panel) and EIO-04
M4 screws to about 10 in-lbs.
Access Point Bracket Usage and Mounting Options
The AP5050U access point can be mounted under a seat, on a wall, or to a pole, which are described in
the following table.
Table 8: AP5050U Mounting Bracket Usage
Mounting bracket and Wall install
part number
EIO-04 under-seat No
housing
KT-147407-02 Yes
bracket; comes with
three bracket parts
KT-150173-01; Yes; place the
extension arm; used KT-150173-01
with KT-147407-02 extension
bracket parts arm on top of
the 1-axis
KT-147407-0
2 tilt part
20 ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
Pole install Under-seat install
No Yes
Yes No
Yes; attach No
the KT-147407-02
pole part to the
extension arm
Install the Access Point
Notes
The access point can be installed
under a seat on a slope or a flat
surface such as stadium floor.
For attaching to a wall or a flat
surface, use the bracket part that
has two holes. For attaching to
a pole, attach the KT-147407-02
pole part on top of the 1-axis tilt
part.
-