Install The Access Point On A Wall Or Flat Surface Using The Kt-147407-02 Bracket Parts - Extreme Networks AP5050U Installation Manual

Install the Access Point
•
1-axis tilt bracket.
•
KT-150173-01 extension arm (see
•
Six M6 screws
•
Four M6 size hex-head screws
•
Screw-in anchors if the access point is being mounted on a wood wall or a concrete surface.
Note
The installer must provide the M6 hex-head screws and screw-in anchors for wall installation.
If you install the access point to the wall using the ART02 bracket, use the following hardware:
•
One access point
•
MBO-ART02 articulating mounting bracket
•
Six M6 hex-head screws
◦ Two M6 hex-head screws to attach the bracket to the access point
◦ Four M6 hex-head screws to attach the bracket to the wall or a flat surface
Note
The cable glands should face down when you install the access point on a wall.
Install the Access Point on a Wall or Flat Surface Using the KT-147407-02 Bracket
Parts
Before You Begin
Hardware requirements for a wall or flat surface installation:
•
Flat part of the KT-147407-02 bracket
•
1-axis tilt part of the KT-147407-02 bracket
•
One access point
•
Six M6 screws
•
Four M6 headsize screws
Install the Access Point on a Wall or Flat Surface Using
KT-150173-01 extension
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
the KT-147407-02 Bracket Parts
arm).
27