Install The Access Point Using Kt-147407-02 Bracket Parts And Kt-150173-01 Extension Arm - Extreme Networks AP5050U Installation Manual

Install the Access Point
Figure 8: 1-axis tilt bracket
Procedure
1. Attach the flat part of the KT-147407-02 bracket to the access point using two M6 screws.
2. Using the 1-axis tilt bracket as a template, mark and drill four holes on a wall or on a flat surface.
3. Attach the 1-axis tilt bracket to a wall or flat surface using four M6 headsize screws.
4. Align the 1-axis tilt bracket part inside the flat part of the KT-147407-02 bracket, and attach the flat
bracket to the 1-axis tilt bracket using four M6 screws.
5. Tilt the access point to a desired angle and tighten the four M6 screws to a torque of 45 in-lbs.
The tilt bracket has +15 degrees to -15 degrees of tilt.
Install the Access Point Using KT-147407-02 Bracket Parts and KT-150173-01
Extension Arm
Before You Begin
The hardware required for installation:
•
Flat part of the KT-147407-02 bracket
•
1-axis tilt part of the KT-147407-02 bracket
•
KT-150173-01 extension arm
•
One access point
Install the Access Point Using KT-147407-02 Bracket
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
Parts and KT-150173-01 Extension Arm
29