Install The Access Point On A Flat Surface Using Eio-04 Brackets - Extreme Networks AP5050U Installation Manual

Install the Access Point
9. Attach the metal L bracket to the access point:
a. Attach the metal "L" bracket to the gland side of the AP5050U access point using two M6
screws.
b. Torque the screws to 35 in-lbs.
10. Install the access point on the slope:
a. Align and center the alignment holes of the access point and the side tab extension holes, and
attach the access point to the tabs using two M6 screws.
b. Attach the gland side of the access point, that has the "L" bracket to the metal sloping bracket
using two M6 screws.
c. Push the access point to the rear as far as it would go.
d. Torque the screws to 35 in-lbs.

Install the Access Point on a Flat Surface Using EIO-04 Brackets

Learn how to install the AP5050U access point on a flat surface.
Before You Begin
Obtain the items shown in the following table.
Table 11: Hardware Requirements for Flat Surface Installation
Item quantity Description
1 AP5050U access point
4 M6 screws with integral washers
4 75 mm service panel shoulder screws
2 Metal "L" bracket
1 Plastic service panel base
1 Plastic service panel top with one captive screw
4 Concrete anchors with nuts, washers, anchor posts, and anchor sleeves
Note
When installing the access point flat against a surface in a location that uses ice melt, the
best practice is to apply an anti-seize material to the screws before attaching them to the
access point metal base.
Note
When installing the access point flat against a surface in a location that uses ice melt, the
best practice is to apply an anti-seize material to the screws before attaching them to the
access point metal base.
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
Install the Access Point on a Flat Surface Using EIO-04
Brackets
25