Installation Do's And Don'ts; Installation Don'ts - Extreme Networks AP5050U Installation Manual

Installation Do's and Don'ts

2. Visually inspect the access point and any other bracket and optional accessories you have ordered
for physical damage.
If there is any damage, contact
3. Review the
4. Be familiar with the information in the installation guide, in particular the
Installation Do's and Don'ts
Learn about various do's and don'ts for each installation option before installing the access point.

Installation Don'ts:

•
Do NOT install the access point side with the user input/output facing upward or angled upward,
toward the sky.
•
Do NOT install the access point or open the console cap when precipitation is falling or is about to
fall.
•
Do NOT remove the gland body. If the gland body is accidently loosened, it must be torqued
immediately to 30 in-lbs.
•
Do NOT let moisture, dirt, pollen, or any other debris to enter the glands or the console.
•
Do NOT get a pressure washer nozzle closer than 24 inches to the glands, console cap, or vent.
18 ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
Extreme Networks
safety guidelines.
Important
The gland body keeps precipitation from entering the access point.
Note
The access point ships with two black gaskets in the box for use with Category 6 (CAT
6) Ethernet cables with a cable diameter from 6.0mm to 9.2mm. This includes unshielded
twisted-pair (UTP) Cat 6 cables. Store these gaskets in a safe place if you do not use them
right away.
The access point has light-gray gaskets pre-installed in the access point glands. The
light-gray gasket handles all CAT 5 and CAT 5E cables, with a cable diameter range from
4.5mm to 6.0mm.
Install the Access Point
Support.
installation do's and don'ts.