Connect the ETH1 or ETH0 Cable through the
Service Panel Base
The ETH1 or ETH0 cable can be connected through the front or the rear hole on the side of the service
panel base.
About This Task
The ETH1 or ETH0 cable is connected through the front or the rear holes on the sides of the service
panel base.
The following hardware is required to attach the ETH1 or ETH0 cable through the rear hole of the
service panel base:
•
ETH1 or ETH0 cable
•
One blank conduit cover to cover the front hole on the side of the service panel base
•
One 3/4 in. or 1/2 in. conduit cover, depending on the circumference of the ETH1 or ETH0 cable
•
Service panel base
•
Service panel top
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
47