Attach The Access Point To A Pole Using Ws-Mbo-Pole01 Bracket And Mbo-Art02 Articulating Mounting Bracket - Extreme Networks ExtremeWireless AP360i ExtremeWireless AP360e Installation Manual

Attach the Access Point to a Pole Using WS-MBO-
POLE01 Bracket and MBO-ART02 Articulating Mounting
Bracket
Attach the Access Point to a Pole Using WS-MBO-POLE01 Bracket and MBO-ART02
Articulating Mounting Bracket
Before You Begin
The following hardware is required:
•
WS-MBO-POLE01 bracket
•
MBO-ART02 bracket
•
Two M6 hex-head screws
•
Four M3 screws, nuts, and washers to attach the WS-MBO-POLE01 bracket to the MBO-ART02
articulating mounting bracket
•
Two cable clamps
•
Access point
Procedure
1. Attach the MBO-ART02 articulating mounting bracket to the access point using two M6 hex-head
screws.
34 ExtremeWireless™ AP360i/e Access Points
Note
You need to provide your own stainless-steel cable clamps. The band must be 0.5 in. (12.7
mm) wide.
Install the Access Point