Table of Contents
Advertisement
Install the Access Point
Attach the Access Point to a Pole Using WS-MBO-POLE01 Bracket and MBO-ART02
Articulating Mounting Bracket
Before You Begin
The following hardware is required:
•
WS-MBO-POLE01 bracket
•
MBO-ART02 bracket
•
Two M6 hex-head screws
•
Four M3 screws, nuts, and washers to attach the WS-MBO-POLE01 bracket to the MBO-ART02
articulating mounting bracket
•
Two cable clamps
•
Access point
Procedure
1. Attach the MBO-ART02 articulating mounting bracket to the access point using two M6 hex-head
screws.
Note
You need to provide your own stainless-steel cable clamps. The band must be 0.5 in. (12.7
mm) wide.
Attach the Access Point to a Pole Using WS-MBO-
POLE01 Bracket and MBO-ART02 Articulating Mounting
ExtremeWireless™ AP460i/e Access Points
Bracket
35
Advertisement
Table of Contents
