Data For Operation And Environment - Beckhoff AL8000 Operating Instructions Manual

Technical data
Data for operation and en-
4.2
vironment
Environmental requirements
Climate category - operation
Ambient temperature during operation
Ambient temperature during transport
Ambient temperature during storage
Power derating
Installation altitude
Permissible humidity in operation
Permissible humidity during transport
and storage
Specifications for intended use
Ventilation
Insulation material class
Protection class
Vibration resistance
Shock resistance
EMC requirements
Approvals
28 ───
Operate linear motors only under the specified environmental
conditions
Operate the linear motors only under the conditions for operation
and the environment listed in this chapter. This ensures a long ser-
vice life and proper operation.
Short-term or long-term operation outside of the specifications
listed here may reduce the service life of the coil parts.
Beckhoff products are designed for operation under certain environ-
mental conditions, which vary according to the product. The follow-
ing specifications must be observed for operation and environment
in order to achieve the optimum service life of the products.
3K3 according to EN 60721
+ 5 °C to + 40 °C
- 25 °C to + 70 °C, maximum fluctuation 20 K/hour
- 25 °C to + 70 °C, maximum fluctuation 20 K/hour
No power derating up to 1000 m installation altitude above sea
level.
At installation heights higher than 1000 m above sea level and
40 °C:
6 % at 2000 m above sea level
17 % at 3000 m above sea level
30 % at 4000 m above sea level
55 % at 5000 m above sea level
95% relative humidity, non-condensing
5 % to 95 % relative humidity, non-condensing
Air-cooled or water-cooled
B
IP64
50 g, 10...2000 Hz according to EN 60068-2-6
100 g, 6 ms according to EN 60068-2-27
conforms to EN 61800-3:2004 + A1:2012
CE, cURus, EAC, UKCA
AL8000 Version: 1.7