Beckhoff AL8000 Operating Instructions Manual page 65

AL806x horizontal
6.2.1.1
AL806x vertical
6.2.1.2
Magnetic plates
6.2.2
Version: 1.7
Before screwing the eyebolts into the coil part, please observe the
following instructions:
• Use thread on the upper side
• Use eyebolts according to DIN 580
• Note thread depths and screw depths for the threads in the coil
part
See Chapter "Mechanical installation, section Assembly, coil
part", [Page 85]
• Use washers if the set screws of the eyebolts are too long
• Use transport belts of the same length for each eyebolt so that
the coil part does not tilt
► Screw eyebolts [1] into the outer adjacent threads on the outer
sides. Make sure to always choose the largest possible distance
from each other
6.2.1.2
If it is absolutely necessary to lift the coil part vertically:
► Screw eyebolts [1] into the outer adjacent threads on the outer
edge
The following options are available for transporting a single mag-
netic plate:
• Without aids, by hand in compliance with the legal requirements
for the lifting of loads
AL8000
Transport and storage
─── 65