Decommissioning; Disassembly - Beckhoff AL8000 Operating Instructions Manual

Disassembly

13.1
Version: 1.7
Disassembly may only be carried out by qualified and trained per-
sonnel.
Read the chapter Documentation notes.
When disposing of electronic waste, make sure that you dispose of
it in accordance with the regulations applicable in your country.
Read and follow the instructions for proper disposal.
WARNING
Risk of injury during disassembly
Permanent magnets are installed in the AL85xx magnetic plates.
Carefully remove the magnetic plates. Make sure that the mag-
netic plates and ferromagnetic objects are not magnetically at-
tracted and that your hands are not between these components.
If you don't take care during the disassembly, opposite magnetic
plates may attract each other without warning and injure your
hands.
Removing the magnetic plates from the machine:
• Push the machine slide to one side and mechanically secure it
against uncontrolled movements
• Attach protective covers to the magnetic plates. The protective
cover is included with the magnetic plates.
• Unscrew and remove the bolts
• Remove the magnetic plate
• Remove the locating pin
• Push the machine slide to the other side and mechanically se-
cure it against uncontrolled movements
• Remove the other magnetic plates in the same way
Removing the coil part from the machine:
• If present: Remove the water cooling
• Disconnect the electrical connector
• Remove the machine slide from guide rails
• Unscrew and remove the bolts
• Separate the coil part from the machine slide
• Remove the locating pins
AL8000

Decommissioning

─── 103