Table of Contents
Advertisement
Assembly
9.2
Coil part
9.2.1
Version: 1.7
WARNING
Warning of strong magnetic attractive forces
Avoid standing within the travel range of the coil part even when
the machine or system is switched off. The permanent magnets
of the magnetic plates and coils of the coil part attract each other.
The high attractive forces cannot be controlled by hand.
Non-observance can result in serious or fatal injuries due to
crushing.
Only use compatible magnetic plates
Only use original magnetic plates from the AL8xxx product series.
Other magnetic plates are incompatible in the pole sequence.
Failure to observe this may result in serious injury and damage to
the machine due to uncontrolled movements of the linear motor.
Use only the drill holes shown
Use only the drill holes shown for the assembly or for other activi-
ties described in these operating instructions. Drill holes not shown
may be present, for example, for production purposes.
Non-compliance will result in damage to the motor.
During assembly, make sure that the magnetic track can be divided
into two sections. The sections must be at least as large as the ma-
chine carriage.
Clean the mounting surfaces
Make sure that all mounting surfaces are oil-free, grease-free and
unpainted. Remove any dirt or dust.
Observe the mounting sequence
First mount the coil part on the machine carriage. Then mount the
machine carriage including the coil part on the guides. Finally,
mount the magnetic plates.
Observe the screw requirements
Observe the minimum and maximum screw depths of the screws.
Information on the screw depths can be found in the individual sec-
tions during mounting. Please observe the permissible torques and
standards.
Loss of force due to asymmetry
Place the coil part symmetrically to the magnetic plate for the
AL806x-1xxx series. For the AL8x2x, AL804x and AL806x-0xxx se-
ries, the coil part is positioned with an offset to the magnetic plate.
Failure to observe this may result in loss of force at the linear motor
and loss of performance in the machine or system.
AL8000
Mechanical installation
───
85
Advertisement
Table of Contents
