Ul-Specific Data - Beckhoff AX8000 Series Manual

UL test report for the AX8000 multi-axis servo system:
All modules (supply, option and axis modules) of the AX8000 multi-axis servo system meet
the requirements of the relevant UL certification authority and may bear the cULus logo and
the E-number E195162 on the type plate. Please note that the tested system group of the
multi-axis servo system has been protected with a current-limiting circuit breaker of type "J"
with 60 A. A higher fuse type has not been tested in accordance with the standards and
guidelines of the UL certification body and is therefore not permitted for a system group.
2.3.2

UL-specific data

What's important:
• Components from the AX8000 multi-axis servo system may be used in an environment with non-
conductive dirt. This corresponds to the degree of soiling 2. Note that occasionally, depending on the
environmental conditions, temporary conductivity can be expected due to condensation.
• The wiring must be done using copper conductors with a thermal conductivity of at least 60 °C - 75 °C.
• Various sizes of motor can be operated. The level of the internal motor overload protection switch is
adjustable.
Canadian economic area!
In Canada the devices are only approved with a transient suppression on the input side.
Technical requirements for the device for transient suppression:
• Rated voltage: 480 V (Ph / GND), 480 V (PH / PH)
• Overload category: 3
• Protection against a rated surge voltage peak: 4 kV
Multi axis servo system AX8000 Version: 1.6
Guidelines and Standards
13