Advanced Service Configuration - Redline RDL-3000 User Manual

RDL-3000
Pass-through: Classify all packets that do not have a VLAN tag, or where the
outermost VLAN ID tag does not match the VLAN ID for any tagged Group.
802.1Q VLAN ID [0-4095]: Enter the VID associated with this Group definition.
This field is applied only when 'Tagged' is selected in the Group Tagging Mode field.
Default Priority: Enter the default 802.1p priority setting.
The default priority value is applied when a Service Group set to Tagged mode (add
VLAN tag) receives a packet with no priority information.

Advanced Service Configuration

DL CIR: Enter the committed information rate for downlink unicast traffic.
UL CIR: Enter the committed information rate for uplink unicast traffic.
DL PIR: Enter the peak information rate for downlink unicast traffic.
UL PIR: Enter the peak information rate for uplink unicast traffic
The traffic each Service transmits over the wireless interface is monitored to enforce
PIR settings (50 - 50000 Kbps). Traffic statistics are reset at the beginning of each
common one-second clock tick. If the maximum throughput is reached on any Service
before the end of the current interval, that Service is excluded from sending additional
traffic until after the next clock tick.
For example, if a Service transmits its full data allocation in the first 650 ms of the
current metering interval, that Service will not receive any additional bandwidth allocation
until the beginning of the next interval (enforced pause of 350 ms).
When adaptive modulation is enabled, automatic adjustments to the modulation/coding
will result in relative changes to the PIR of all Services and Service Groups using that
wireless link. Incorrect PIR settings may result in excessive latency or dropped packets
(buffer full condition).
Controls
Apply: Click to accept and activate displayed settings.
User Manual