Advanced Wireless Configuration; Table 8: Web - Maximum Tx Power Settings (Dbm) - Redline RDL-3000 User Manual

RDL-3000
Modulation
Code Rate
Max. Tx Power

Advanced Wireless Configuration

Max. Distance [km]: (SC only) Enter the distance to the subscriber located farthest from
the sector controller.
DFS Action: (SC only) Select the mode of operation for DFS.
The sector controller monitors for interference from radar devices and other equipment
using the same channel frequency. When interference is detected, the unit will
automatically take the selected action:
None: The DFS function is disabled.
Note: Where DFS is required by regional regulations, this feature is permanently
enabled at the factory and can not be disabled by the installer or end-user.
Tx Off: When radar signals are detected, the transmitter is immediatelly switched off,
an event message is logged, and configured SNMP trap messages are sent. After
thirty minutes the unit monitors the RF channel for one minute. If radar signals are
detected, the transitter remains disabled and the unit waits thirty minutes before
repeating the monitoring period. Normal operation resumes only when radar signals
are not detected during a one minute monitoring period.
Chg Freq: When radar signals are detected, the transmitter is immediatelly switched
off, an event message is logged, and configured SNMP trap messages are sent. The
unit changes frequency and monitors the new RF channel for one minute. If radar
signals are detected during the monitoring period, the tramsitter remains disabled
and the unit switches to the next frequency to be tested. Normal operation resumes
only when radar signals are not detected during a one minute monitoring period.
Antenna Gain: Enter the antenna gain specified by the manufacturer. This field is
required only when the DFS Action is set to Tx Off or Chg Freq.
Important: It is important to enter the gain value specified by the manufacturer. If the
gain is set higher than the actual antenna gain, the sensitivity will be too low and the
RDL-3000 will not be operating in compliance with the DFS standards. If the gain is
set lower than the actual antenna gain, the RDL-3000 will be more sensitive to
interference and this may cause false DFS triggering.
Antenna Alignment Buzzer Enable: (SS only) Audible antenna alignment tool.
Disabled ( ): The antenna alignment tool is disabled (no sound).
Enabled ( ): The antenna alignment tool is active. Faster repetition rates of the
sound indicate a stronger signal is being received from the remote-end transmitter.
Registration Period [frames]: (SC only) The sector controller provides opportunities for
unregistered subscribers to contact the sector controller and attempt to establish a
wireless data link. The Registration Period specifies the number of wireless frames (1 to
100) to wait between transmitting these polling messages. For example, entering a value
of '4' will include a registration opportunity in every 4th wireless frame.
Scheduling Cycle: Enter the period of the traffic scheduling cycle. Choosing the
scheduling cycle period is generally a balance between providing lower latency (shorter
cycle) and more efficient packet processing (longer cycle). The effects of changes to the
User Manual

Table 8: Web - Maximum TX Power Settings (dBm)

BPSK QPSK 16 QAM
1/2 1/2 1/2
22 22 22
64 QAM
3/4 2/3 3/4
22 22 22