Load - Redline RDL-3000 User Manual

RDL-3000
werxpkt
Wireless Eth Rx packets.
werxpktdis
Wireless Eth Rx discarded packets.
werxpkterr
Wireless Eth Rx packets with errors.
wetxpkt
Wireless Eth Tx packets.
wetxpktdis
Wireless Eth Tx discarded packets.
wetxpkterr
Wireless Eth Tx packets with errors.
5.3.10

load

Use the load command to install encryption keys into the RDL-3000.
load <file> <idtable> <script>
file <server IP> <filename> <usr | factory | fips> <tftp | sftp> <user> <password>
Load a key or certificate file from FTP server. The file is saved in non volatile RAM area. A
reboot is required to activate changes to security data. The filename must be one of the
following:
dsa_key_<mac>.pem
rsa_key_<mac>.pem*
ssl_cert_<mac>.pem
ssl_key_<mac>.pem
usr_wcert_<mac>.der** User wireless certificate.
usr_wkey_<mac>.der
usr_wacert_<mac>.der User wireless authority certificate.
The <mac> portion is the MAC address of the board.
For example: dsa_key_00-09-02-00-01-02.pem
Specify where to store the security information.
usr
factory Default files.
fips FIPS mode files (FIPS mode must be active).
For example:
load file 192.168.25.10 ssl_key_00-09-02-00-b2-73.pem usr tftp
idtable (no parameters)
Load all IDs from flash memory. This can be used to restore all IDs from the last saved
configuration.
script <server IP> <filename>
Use this command to load the RDL-3000 configuration information from a file (created using
script command) located on a remote TFTP server. The file must be located in the TFTP
default directory. The 'save config' command must be used to save the loaded configuration
in non volatile memory. A reboot may be required to activate the loaded configuration
settings.
For example:
load script 192.168.25.10 RDL3000-Unit035-091121.cfg
User Manual
DSA key used for SSH.
RSA Key used for SSH.
SSL Certificate.
SSL Key.
User wireless key.
User entered files (default if type is not specified).