Wireless Security; Fig. 46: Web - Wireless Security Screen - Sector Controller - Redline RDL-3000 User Manual

RDL-3000
4.5.5

Wireless Security

Click Configuration->Wireless->Security
Click to expand or
Encryption Type: Select the encryption type to use for data transmitted over the
wireless interface. If an encryption type is selected, the identical setting must be made
on both communicating units before Ethernet packets can be transferred over-the-air.
None: Encryption is disabled.*
AES 128: Advanced Encryption Standard using 128-bit encryption.
AES 192: Advanced Encryption Standard using 192-bit encryption.
AES 256: Advanced Encryption Standard using 256-bit encryption.
Shared key: Enter the encryption key to be shared between the sector controller and all
subscribers in this sector. This is required only when encryption is enabled.
Shared key confirmation: Re-enter key to minimize errors. This field must be identical
to the Shared Key field.
X.509 Authentication Enable: Check this box
installed X.509 certificate. The user-defined unit certificate, authority certificate, and RSA
private key must be downloaded using the CLI 'load' command.
Note: This dialog item is visible only if enabled by the Options Key and X.509 certificates
are loaded on the RDL-3000.
Fast Registration Enable: Check this box
shared keys for quick authentication of a subscriber (bypass Diffie-Hellman method).
This feature is not available in FIPS mode.
SC MAC: (Subscriber only) MAC address of the sector controller. The subscriber will
establish a wireless link only with the sector controller having the MAC address recorded
in this field. If this field is blank, the subscriber will establish a wireless link with any
sector controller.
Apply: Click to activate the security settings displayed on this screen.
Apply & Save All: Click to activate and permanently save the security settings on this
screen. Saved settings are restored on power-up, reboot, or at the end of a test cycle.
User Manual
to hide fields.

Fig. 46: Web - Wireless Security Screen - Sector Controller

to display the Security Configuration screen.
to require authentication using an
to enable the sector controller to use pre-