Rf Jumper Cables; Ground Lug; Audible Alignment Tool; Management Interfaces - Redline RDL-3000 User Manual

RDL-3000
Important: A factory-installed protective weatherproof plastic cap is installed on the RF
ports. When a cap is removed to install an antenna cable, the port must be adequately
weatherproofed. Refer to the RDL-3000 Installation guidelines for detailed instructions.
2.6

RF Jumper Cables

Two RF jumper cables are provided with each RDL-3000 mounting kit. The RF cables
conduct RF signals between the RDL-3000 and the antenna system. The cable length
supplied (230 mm or 400 mm) is based on the type of mounting kit.
2.7

Ground Lug

A ground-lug
a grounding wire. All RDL-3000 systems must be properly grounded to protect against
power surges and accumulated static electricity.
2.8

Audible Alignment Tool

The audible alignment tool is provided to assist the installer to perform basic antenna
alignment. When enabled, the audible alignment signal 'chirps' slowly when a low signal
level is detected, and faster when stronger signals are detected. The tool is enabled and
disabled using the Web or CLI interface.
2.9

Management Interfaces

The operator can use a standard Web browser or Telnet client to access all settings and
statistics necessary to configure and monitor the operation of the RDL-3000. The unit
can also be configured monitored using the SNMP-based Redline ClearView NMS .
User Manual

Fig. 4: Features - RDL-3000 RF Ports (Top View of Radio)

Fig. 5: Features - RDL-3000 - RF Jumper Cables

is provided on the RDL-3000 chassis. Use this connection to terminate