Wireless Summary; Wireless Ethernet Statistics; Fig. 29: Web - Ss System Status Screen - Redline RDL-3000 User Manual

RDL-3000
Chg Freq: Radio transmitter is changed to a different RF frequency.
Status Code: Code indicating the status of the RDL-3000 system. Code '0000 0000'
indicates normal operation. Refer to the troubleshooting section of this manual.
GPS Status: Display the status of the internal GPS unit.
N/A: The GPS device is not installed (or is malfunctioning).
No Signal: There is no signal detected on the PPS port.
Locked: The RDL-3000 internal clock is synchronized to the PPS signal.
Synchronization Status: Display the synchronization status.
N/A: This message is displayed for the following conditions:
a) Synchronization mode is disabled.
b) Synchronization mode is enabled and PPS port is disabled.
No Signal: There is no signal on the PPS port.
Acquiring: A PPS signal is detected and the internal clock is being synchronized.
Locked: The internal clock is synchronized to the PPS signal.

Wireless Summary

Subscriber Links: Status of the wireless links to subscribers.
Configured: Number of provisioned Subscriber Links (subscriber will always indicate
a value of 1).
Active: Number of subscribers that are online (registered with sector controller).
Subscriber Services: (Subscriber only) Status of the Services for this subscriber.
Configured: Number of provisioned Services.
Active: N/A
Services: (Subscriber only) Status of the Services on this subscriber.
Configured: N/A
Active: Number of active Services.

Wireless Ethernet Statistics

Buffered Packets: Number of packets successfully transmitted and received over the
wireless interface, excluding discarded packets and packets with errors.
Rx: Wireless packets received.
Tx: Wireless packets transmitted.
Discarded Packets: Number of packets discarded by this unit.
Rx: Received wireless packets that have been discarded (e.g., Rx buffer overflow).
Tx: Transmitted wireless packets that have been discarded (e.g., Tx buffer overflow or
packets not acknowledged by the remote end unit).
Lost Packets: Total number of packets containing errors.
Rx: Received wireless packets with errors (e.g., CRC).
User Manual

Fig. 29: Web - SS System Status Screen