Dashboard Display; General Information; Wireless Leds; Link Led - Redline RDL-3000 User Manual

RDL-3000
4.3

Dashboard Display

4.3.1

General Information

The dashboard is displayed at the top of all Web screens. This feature displays a
summary of important operational information.
IP Address: IP address of this unit.
Wireless Frequency: RF frequency in-use by this unit.
Time: Local time obtained from the Web browser.
Test time: Visible only when the
restored when the counter reaches zero (unit is not rebooted). Click
menu at any time to permanently save the current running configuration.
Unsaved Data: Indicates if the running configuration matches the saved configuration.
No: There are no differences between the running and saved configurations.
Yes: There are unsaved changes to the configuration. Unsaved settings are discarded
when the system is rebooted. Click
current running configuration.
Saving: The system is saving the runtime parameters to non-volatile RAM.
Radio Temperature: Internal temperature of the radio.
4.3.2

Wireless Leds

The Wireless LED indicators indicate the status of the wireless link.

Link LED

This LED is not implemented in the current software release.

Signal LED

This indication is valid only when the Link LED is on solid green. If Adaptive Modulation
is enabled, the threshold refers to the 'minimum UBR' setting.
On: Wireless link is operating at or above the requested UBR.
Blink: Adaptive modulation is enabled AND the wireless link is operating below the
minimum UBR.
4.3.3

Ethernet LEDs

These LED indicators provide a summary of the Ethernet port status.
Link LED
Off: Ethernet connection is not detected (e.g., Ethernet cable is disconnected).
On: Ethernet link is detected.

100 LED

Off: Ethernet port is operating at 10 Mb/s.
On: Ethernet port is operating at 100 Mb/s.
User Manual

Fig. 26: Web - Dashboard Display

Test function is active. The last saved configuration is
Save All in the main menu to permanently save the
Save All in the main