Wireless Links; Fig. 9: Pmp - Wireless Subscriber Links - Redline RDL-3000 User Manual

RDL-3000
Operation in PMP mode is controlled by the options keys. Enter PMP-enabled options
keys before deploying and configuring the RDL-3000 units. The options keys enable
specific PMP options, including the total number of subscribers. A specific range of RF
power settings are provided for PMP operation.
Ethernet data traffic can not be transmitted over the wireless interface until at least one
Link, Service Group, and Service have been provisioned. All provisioning is performed
on the sector controller:
Link: Enable a wireless connection between the sector controller and a subscriber
and set the uplink and downlink rates uncoded burst rates (UBR). Rates are set
individually for each link.
Service Group: Define packet filtering at the sector controller Ethernet port and set
parameters for broadcast/multicast groups.
Service: Define packet filtering at the subscriber Ethernet port and set parameters
for subscriber (unicast) traffic.
3.2.1

Wireless Links

A Link enables a wireless connection from the sector controller to the subscriber and
sets the uplink and downlink rates (UBR). The sector controller will only communicate
with registered subscribers. Each link is uniquely identified with a name and the MAC
address of the subscriber.
User Manual

Fig. 9: PMP - Wireless Subscriber Links