Fig. 44: Web - Wireless Configuration Screen -- Subscriber - Redline RDL-3000 User Manual

RDL-3000
RF Freq. [MHz]: Enter the center frequency for the RF channel.
RF frequency range settings are restricted by the active options key.
Important: To minimize interference between RDL-3000 links operating in close
proximity, RF frequency settings should be separated by a guard interval equal or
greater than the channel size. For example, when using a 20 MHz channel, the RF
frequencies should be separated by >20 MHz.
Auto scan: (Subscriber Only) Check this box
automatically scan available RF frequency ranges to locate and register with a sector
controller. When Auto scan is not enabled, the wireless link can be established only at
the frequency specified in the RF Freq. [MHz] field.
By default, the subscriber will scan all available frequency bands enabled by the options
key.
To reduce the scanning/connection time, the operator may specify a subset of frequency
ranges to scan. Click on the main menu item Configuration ->
the Frequency Management
Tx Power [dBm]: Enter the transmit power level (dBm) (measured at the RDL-3000 RF
port). The actual system EIRP will be the power setting plus the gain of the connected
antenna. See the following tables to determine the maximum transmit power setting
allowed at each modulation level. When DFS is enabled, the subscriber Tx power may
be adjusted automatically to avoid false triggering of the DFS feature.
Important -- EIRP Levels: Where required by local regulations, the maximum
operational power per channel for a specific antenna must not exceed the maximum
allowable EIRP levels. The RF output power settings must be professionally
programmed by the manufacturer or a trained professional installer. Refer to the FCC
and IC notices in this manual (refer to Section 1 and Section 7).
User Manual

Fig. 44: Web - Wireless Configuration Screen -- Subscriber

screen.
to enable the subscriber to
Frequencies to display