Frequency Management Screen; Table 9: Web - Radio Enable - Rf Port Settings - Redline RDL-3000 User Manual

RDL-3000
set to high impedance (None). Refer to the RDL-3000 Installation Guidelines for more
information.
None: Port termination is high impedance.
50 Ohms: Port termination impedance is 50 Ohms.
75 Ohms: Port termination impedance is 75 Ohms.
Radio Enable: Select the operational mode.
Refer to the following table to determine the required RF settings.
Setting
Off
RF Port 1
RF Port 2
IMPORTANT: Version 1.xx operation is limited to port RF-1. Port RF-2 must be
electrically terminated (connect antenna or RF terminating device) and must be
weatherproofed.
Apply: Click to accept and activate the wireless settings displayed on this screen.
Apply & Save All: Click to permanently save the wireless settings displayed on this
screen. Saved settings are restored on power-up, reboot, or at the end of a test cycle.
Note: Clicking on another main menu item before clicking Apply or Apply & Save All
discards all changes made to settings displayed on the Wireless Configuration screen.

Frequency Management Screen

Click Configuration->Wireless->Frequencies
screen. Use this screen to create frequency lists for subscribers to quickly locate and re-
register with the sector controller. Up to 32 frequency ranges may be entered.
Following any subscriber power-cycle, reboot, or temporary loss of the wireless link
(e.g., transient interference) the subscriber first checks any frequencies in the Local
Frequency Ranges table. If a sector controller is not located, then the subscriber will
scan all available frequencies.
Important: The Auto scan feature must be enabled on the subscriber to use the
frequency lists. If Auto scan is disabled, the subscriber only monitors the channel
selection in the RF Frequency field.
User Manual

Table 9: Web - Radio Enable - RF Port Settings

Mode
RF Disabled
SISO
SISO
RF Port 1 RF Port 2
Tx Rx Tx
X X X
X
X X
to display the Frequency Management
Rx
X
X