Step 4: Required Wireless Settings; Table 15: Procedures - Rdl-3000 Parameter Settings; Figure 42: Procedures - Configuration - Product Options Screen - Redline RDL-3000 Installation Manuallines

RDL-3000
5.5.4

Step 4: Required Wireless Settings

Review and adjust the following parameters as required. Refer to the site survey
information.
Step Screen
1 Utilities
->Product
Options
2 Configuration
->System
3 Configuration
->Wireless
4 Provisioning
->Subscriber
Links
Notes: 1. DFS enabled systems only.
70-00159-01-06
INSTALLATION GUIDELINES

Figure 42: Procedures - Configuration - Product Options Screen

Table 15: Procedures - RDL-3000 Parameter Settings

Parameter
Options Key
System Name
IP Address
System Mode
Channel Width
RF Freq.
Tx Power
Max. Distance
Antenna Gain
Subscriber MAC
Proprietary Redline Communications © 2012
Ref. Sector Controller
RF Plan Enable PMP SC
mode, RF freq., etc.
Net. Plan Name for SC
Net. Plan IP address for SC
RF Plan PMP SC
RF Plan Use the same setting for SC and SS.
RF Plan Use the same setting for SC and SS.
RF Plan Refer to RF Plan
RF Plan Refer to RF Plan
1
RF Plan See Mfg. Spec.
RF Plan MAC address of
each subscriber in
the sector.
Subscriber
Enable PMP SS
mode, RF freq., etc.
Name for SS
IP address for SS
PMP SS
Refer to RF Plan
N/A
1
See Mfg. Spec.
N/A
Page 50 of 65
1
kune 12, 2012