Polycom RMX 2000 Getting Started Manual page 41

In a dial-in connections, the MCU CLI indicates the MCU's number
dialed by the participant. In a dial-out connection, indicates the MCU
(CLI) number as seen by the participant
29 Click Save & Continue.
After clicking Save & Continue, you cannot use the Back button to
return to previous configuration dialog boxes.
The ISDN/PSTN Network Service is created and is added to the ISDN/
PSTN Network Services list.
If the system cannot create the ISDN/PSTN Network Service, an error
message is displayed indicating the cause and allowing you access
the appropriate dialog box in the Fast Configuration Wizard for
corrective action.
30 Click OK to continue the configuration.
The Spans dialog box opens displaying the following read-only fields:
— ID – the connector on the ISDN RTM card (PRI1 to PRI12).
— Slot – the MPM board that the ISDN RTM card is connected to
(MPM 1 or MPM 2).
— Service – the ISDN/PSTN Network Service to which the span is
assigned.
— Clock Source – indicates if ISDN signaling synchronization is
being supplied by the Primary or Secondary clock source. The first
span to synchronize becomes the Primary clock source.
Polycom RMX 2000 Getting Started Guide
2-25