First Time Installation And Configuration; Hardware Installation And Setup - Polycom RMX 2000 Getting Started Manual

First Time Installation and
Configuration
Hardware
Installation
and
Setup
Gather Network
Equipment
and
Address Info
First Entry
Configuration
First Time Installation and Configuration of the RMX 2000 consists of the
following procedures:
1

Hardware Installation and Setup

— Mount the RMX in a rack.
— Connect the necessary cables.
2 Gather Network Equipment and Address Information
— Get the information needed for integrating the RMX into the
local network.
3 First Entry Configuration
— Register the RMX.
— Power up the RMX.
— Modify the Management Network.
— Configure the Default IP Network Service.
— Configure the ISDN/PSTN Network Service.
Hardware Installation and Setup
The RMX unit should be mounted in a 19"rack in a well ventilated area. It
is important to adhere to the Site Requirements as described in the RMX
2000 Hardware Guide, "Site Requirements" on page 1-3.
2
2-1