Headlight Housing Removal; Headlight Housing Installation; Taillight Replacement - Polaris ACE 900 2017 Service Manual

HEADLIGHT HOUSING REMOVAL

1. Disconnect the wire harness from the headlamp bulb.
Be sure to pull on the connector, not on the wiring.
2. Remove the O-rings (A) from the headlamp brackets
on both sides of the headlamp.
3. Remove the adjustment screw
4. Carefully remove the headlamp from the front
bumper.
9929422 R02 - 2017-2019 ACE 900 Service Manual
© Copyright Polaris Industries Inc.

HEADLIGHT HOUSING INSTALLATION

1. Install the headlamp housing back into the front
2. Secure the headlamp housing with the rubber Orings
q
from the bracket.
3. Reconnect wire harness or re-insert bulb if previously
4. Adjust headlights using the "Headlight Adjustment"

TAILLIGHT REPLACEMENT

Before replacing the taillight(s), use a digital multi-meter
to test the harness to ensure the lamp is receiving 12
volts and that a ground path is present.
1. Disconnect the wire harness
2. While holding the taillight assembly, remove the three
bumper.
(A) on both sides of the headlamp and install the
adjustment screw (B).
removed.
procedure in this section.
NOTE
Taillight is non-servicable. Must be replaced as an
assembly.
q
w
nuts retaining the taillight assembly and remove it
from the rear fascia.
ELECTRICAL
.
11
11.45