Polaris ACE 900 2017 Service Manual page 273

19. Install and properly route the vent hose
20. Grease the front gearcase and transmission input
shaft splines with Premium All Season Grease. Install
the prop shaft onto the transmission input shaft. Align
the hole in the front of the prop shaft with the hole in
the front gearcase input shaft and install the prop
shaft. Hammer a new spring pin
it is flush with yoke.
21. Reinstall the PVT system outer clutch cover, drive
belt, drive clutch, driven clutch, inner clutch cover and
clutch outlet duct. See PVT Assembly page
9929422 R02 - 2017-2019 ACE 900 Service Manual
© Copyright Polaris Industries Inc.
a
. 22. Install new spring ring
an anti-seize compound to the splines
23. Rotate the rear upper control arm back into position
on the frame while guiding each drive shaft back into
the transmission. Verify the driveshaft "click" into
place.
s
into the hole until
24. Torque upper control arm fasteners to specification.
25. Reinstall the floorboard panel using the screws and
plastic rivets. Torque screws to specification.
26. Reinstall the rear wheels. Torque lug nuts to
specification.
TRANSMISSION
a
on rear drive shafts. Apply
s
TORQUE
Upper Control Arm Fasteners:
42 ft-lbs (57 Nm)
TORQUE
Floorboard Screws:
8 ft-lbs (11 Nm)
TORQUE
Wheel Lug Nuts:
30 ft-lbs + 90° (41 Nm)
.
6
6.17