REMOVAL
w
1. Install new seal
into crankcase. Thread the drive
bolt of special tool PU-52493
IMPORTANT
The orientation of the seal is critical. Install the seal with
the flat side of the seal facing out as shown.
9929422 R02 - 2017-2019 ACE 900 Service Manual
© Copyright Polaris Industries Inc.
2. Tighten the drive bolt
q
into the crankshaft.
3. Once the seal is properly installed, loosen the drive
4. Refer to PVT Inner Cover Assembly page
5. Test drive the vehicle and recheck for leaks before
ENGINE / COOLING SYSTEM
e
until the cylinder
out against the crankcase.
e
bolt
and remove special tool PU-52493 from the
crankshaft.
putting back into service.
r
bottoms
3
.
3.31