Ball Joint Installation - Polaris ACE 900 2017 Service Manual

STEERING / SUSPENSION
2. Using PU-50506, install spacer
ball joint face.
3. Place Removal Adaptor
4. Install the Press Asm.
the ball joint Removal Adapter.
Be sure the Press Asm. opening is only contacting the
q
Spacer and not the ball joint face.
5. Tighten the Press Asm. screw and fully remove the
ball joint from the A-arm.
8.26
q
over the top of the
w
over the ball joint shaft.
e
onto the A-arm to engage
NOTE

BALL JOINT INSTALLATION

Upper Ball Joint Removal
1. By hand, install the NEW ball joint into the A-arm.
2. Using a press, carefully drive in the new ball joint into
the A-arm.
3. After the new ball joint
w
arm , install a new retaining ring
4. Repeat the ball joint service procedure for any
additional A-arm ball joint replacements.
5. Insert upper / lower A-arm ball joint end into the
bearing carrier. Install new pinch bolt and nut on
upper ball joint or new cotter pin and nut on lower ball
joint. Torque to specification.
6. If needed, install new brake caliper mounting bolts
and torque to specification.
CAUTION
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
mounting bolts upon assembly.
9929422 R02 - 2017-2019 ACE 900 Service Manual
q
is fully installed into the A-
e
.
© Copyright Polaris Industries Inc.